Modifications

Our Modifications are on new and existing equipment to be fitted onsite.

We modify all sorts of things, a few photos below are things we come across to fix a problem.

We needed to remove 6mm from the top hinge so the gate would fit the hinge. We needed to remove 6mm from the top hinge so the gate would fit the hinge.
Ground down top spacer plate so hinge would fit.Ground down top spacer plate so hinge would fit.
Low roof on a school we made a 2M bracket with a 12 degree pitch to fit the fascia and keep the bracket verticalLow roof on a school we made a 2M bracket with a 12 degree pitch to fit the fascia and keep the bracket vertical
Bottom eye plate installed 8mm to high no problem we ground 2mm off itBottom eye plate installed 8mm to high no problem we ground 2mm off it
Repainted ready to hang gateRepainted ready to hang gate
Cutout elbow on hi-bar barrier this is to allow the arm to raise to 90 degreeCutout elbow on hi-bar barrier this is to allow the arm to raise to 90 degree
We where asked to install a front door intercom on a new modular school. We where told not cable inside the school as they wanted to keep a clean look. No problem.We where asked to install a front door intercom on a new modular school. We where told not cable inside the school as they wanted to keep a clean look. No problem.
We cabled outside in conduit and TIG welded the Z bracket together as it was hanging right out, this was because the door was set deep in the wall.We cabled outside in conduit and TIG welded the Z bracket together as it was hanging right out, this was because the door was set deep in the wall.